To ensure the longevity and comfort of your silicone crochet hook handle, please adhere to the following care guidelines.
Fitting the Handle
- Insert the head of the crochet hook from the bottom of the Hook Helper.
- Gently push upwards until the handle is fully in place.
- Adjust the angle and position of the crochet hook as necessary.
The Hook Helper fits crochet hooks sized 2mm to 5mm comfortably, though it can accommodate slightly larger or smaller hooks with care.
Removing the Handle
- Push down on the handle while squishing it vertically to create air pockets between the silicone and the hook.
- Slide the Hook Helper off the crochet hook. If it feels stuck, twist the hook left to right inside the handle as you pull on it.
Do not use sharp objects to pry it off, as this may puncture or tear the silicone. Avoid excessive force and take care not to injure yourself, as crochet hooks can be sharp.
Using with Larger Hooks
- If using a larger hook that is more difficult to insert, place the bottom of the hook against a solid surface (e.g., a table).
- Hold onto the sides of the silicone handle and gently push down to fit it onto the hook.
Be cautious, as the hook may slip and could cause injury.
Do not use lubricants or powders (such as oil, baby powder, or similar substances), as they may affect the silicone’s texture and durability. I have found that wetting the crochet hook or washing the silicone handle before fitting can make it easier to slide the handle on and off.
Cleaning & Maintenance
- Silicone naturally attracts dust and fluff – this is normal. To clean, wash with warm water and mild hand soap (the same type you use daily).
- Scrubbing is typically unnecessary, but a soft sponge can be used if needed.
- Avoid harsh chemicals, as they may corrode the silicone.
- If sanitisation is required, you can use rubbing alcohol, though frequent use is not recommended.
By following these care tips, your silicone crochet hook handle will remain in great condition for long-term use. Happy crocheting! ❤
Our spinning yarn holder comes flat-packed for safer shipping. This allows me to ensure that all fragile parts, such as the pins, are securely wrapped and well-protected during transit.
Flat-packing also reduces the risk of damage and keeps your yarn holder in perfect condition for when it reaches you. Assembly is quick and easy – just follow the instructions below to set it up in under a minute!
- Place the base on a solid surface (e.g., a table). The small rubber legs on the bottom prevent movement and protect your table from scratches.
- Take the bottom pin and firmly push it into the hole in the centre of the base.
- Grab the spinner section and the top pin. Push the top pin through the hole in the middle of the spinner until secured in place.
- Take the assembled spinner section and place it onto the bottom pin.
- Your yarn holder is now fully assembled and ready to spin freely!
And you’re ready to enjoy a smooth yarn pull with your brand new spinning yarn holder. Happy crocheting!
Our portable yarn holder comes flat-packed for safer shipping. This allows me to ensure that all fragile parts, such as the middle pin, are securely wrapped and well-protected during transit.
Your portable yarn holder is designed for convenience, allowing you to crochet anywhere, anytime! Follow these simple steps to assemble it:
- Take the base and the middle pin. Push the middle pin through the hole in the centre of the base, securing it in place.
- Place your yarn onto the pin.
- Take the wrist strap and secure it to the pin using the clasp.
- Your portable yarn holder is now fully assembled and ready to go!
Enjoy smooth, tangle-free crocheting wherever you are – even while on the move. Happy crocheting!